Differences

This shows you the differences between two versions of the page.

--- tools:s-tk:prefs [2019/07/30 13:07] – [Spline Preferences] lightwolf
+++ tools:s-tk:prefs [2019/08/08 14:58] (current) – lightwolf
@@ Line 1: / Line 1: @@
 ====== Spline Preferences ======
-{{ :tools:s-tk:pasted:20190730-125730.png}}
+{{ :tools:s-tk:pasted:20190808-145355.png}}
 This Master Plugin defines the defaults for splines in the current scene. The settings are saved with the scene.
 ===== Controls =====
-==== Evaluation Steps ====
-==== Selected Steps ====
-==== Deselected Steps ====
-==== Selected Width ====
-==== Deselected Width ====
 ==== Show Knots ====
+Displays a small circle at the position of the knots in the viewport.
 ==== Show Start/End Knots ====
-==== Show Normals ====
+Displays a small circle at the position of the starting and ending knot of a spline in the viewport. This uses the colours defined below.
 ==== Start Colour ====
 This is the colour used to draw the first knot in a spline (if Show Start/End Knots is enabled) and also to draw the main handle of the incoming control point of a knot.
@@ Line 19: / Line 18: @@
 This is the colour used to draw the last knot in a spline (if Show Start/End Knots is enabled) and also to draw the main handle of the outgoing control point of a knot.
+==== Selected Spline / Deselected Spline ====
+The following settings are available for selected and deselected spline. This allows you to reduce clutter in the viewport for splines that aren't selected.
+=== Display Steps per Knot ===
+This is used when the spline is selected and drawn into a viewport.
+The value is number of lines drawn in the layout viewport per span to approximate the shape of the spline. The higher the value, the smoother the viewport representation is.
+However, a larger value also takes longer to draw and uses a bit more memory.
+This value can be quite low if you have many splines in your scene and the ones you don't have selected don't have to be as precise.
+=== Line Width ===
+The width of the lines used to draw a selected spline in the viewports in pixels.
+=== Display Alignment ===
+This shows the orientation along the spline as well as the influence of the up vector.
+  * **None** Doesn't show any normals.
+  * **Every Step** Shows the normals for every Evaluation Step.
+  * **Knots Only** Only shows the normals at the knots.
+  * **Ribbon** Doesn't show the normals but displays the spline as a ribbon.