This Master Plugin defines the defaults for splines in the current scene. The settings are saved with the scene.

The number of cached values per span that are used to compute the orientation along the spline. If you find the orientation to be “jaggy”, increase this value.

This is used when the spline is selected and drawn into a viewport.

The value is number of lines drawn in the layout viewport per span to approximate the shape of the spline. The higher the value, the smoother the viewport representation is. However, a larger value also takes longer to draw and uses a bit more memory.

This is used when the spline is not selected and drawn into a viewport.

The value is number of lines drawn in the layout viewport per span to approximate the shape of the spline. The higher the value, the smoother the viewport representation is. However, a larger value also takes longer to draw and uses a bit more memory.

This value can be quite low if you have many splines in your scene and the ones you don't have selected don't have to be as precise.

The width of the lines used to draw a selected spline in the viewports in pixels.

The width of the lines used to draw a deselected spline in the viewports in pixels.

Displays a small circle at the position of the knots in the viewport.

Displays a small circle at the position of the starting and ending knot of a spline in the viewport. This uses the colours defined below.

This shows the orientation along the spline as well as the influence of the twist angle.

• None Doesn't show any normals.
• All Shows the normals for every Evaluation Step.
• Knots Only Only shows the normals at the knots.

This is the colour used to draw the first knot in a spline (if Show Start/End Knots is enabled) and also to draw the main handle of the incoming control point of a knot.

This is the colour used to draw the last knot in a spline (if Show Start/End Knots is enabled) and also to draw the main handle of the outgoing control point of a knot.